ADC 2
6.8. Error
messages
Error #
Description
30
There is no glass chamber or the chamber is not in
the correct position.
31
The lever is in the up position.
32
The drying compartment door is open.
33
The position of the humidity module valve was not de-
tectable.
34
The changing of positions of the humidity module
valve was lasting too long, i.e. valve is locked or dirty.
35
There is no solvent (mobile phase) in the chamber.
36
There is no TLC plate in the ADC2.
37
Humidity / temperature sensor damaged, bad con-
nection or failed.
38
Migration front is moving backwards. There is too lit-
tle solvent available or there are temperature prob-
lems, e.g. due to sun light.
39
Tolerances of TLC plate or TT-Chamber too big.
40
The TT-Chamber has been moved during develop-
ment.
41
The drying compartment lid has been opened during
development.
42
The lever has been moved to the up position during
development.
45
The humidity module is disconnected or there is no
module present.
47
The edge of the plate holder could not be detected
while lowering the plate into the TT-Chamber.
59
Interruption of chromatography by mains power fail-
ure
100
Spindle drive (drying comp.): ref-switch (LSX) active
101
Lift drive (plate lift): ref-switch (LSX) active
104
Spindle drive (drying comp.): ref-switch was expected
105
Lift drive (plate lift): ref-switch was expected:
120
Internal device voltage 24V too low
Manual, August 2005
Page 27