cam GARA S139, Instructions For Use Manual

Page: 17 / 76

16
INSTRUCTIONS FOR USE
two parts underlined with the bLUE point
(in the lower part of the car seat). make the
“T” part of the belt pass through the parts
underlined with the bLUE point.
17. make sure that the harness is
assembled in the right way by comparing
it to the diagrams.
18. To make sure the car seat is well fitted,
pull firmly the harness.
WARNING: make sure the car seat is
correctly touching both the bottom of the
seat and the backrest of the seat. If it’s not
adhering to the seat of the car, it means
the car seat was not fitted in the right way
or the harness has been adjusted in the
wrong way.
GROUP 1 CAR SEAT: FROM 9 TO 18 KGS
19. Place the car seat in the vehicle seat
unit as shown in the diagram. The base
must be well positioned and adhering in
the right way to the vehicle seat unit.
20. Recline completely the backrest to make
all next operations easier (please note that
the button on the car seat backrest must be
used only for gROUP 0+!)
21. Fasten the 3 point belt of the car
making sure it is passing through the
space as shown in the figure.
22. Open the harness locking devices
shown in the figure by pulling
upwards the levers.
23. Place the lap belt “A” under the
locking devices and close them until
you hear a “click”.
24. Place the diagonal belt “T” in the
upper part underlined in red.
25. make sure the harness is
assembled in the right way by
comparing it to the diagram.
26. To make sure the car seat is well
fitted, pull firmly the harness.
WARNING: make sure the car seat is
correctly touching both the bottom of the
seat and the backrest of the seat. If it’s not
adhering to the seat of the car, it means
the car seat was not fitted in the right way
or the harness has been adjusted in the
wrong way.
IT IS POSSIbLE TO ADJUST ThE CAR SEAT
bACKREST IN ThE DESIRED POSITION
bUT ONLy IF yOU USE IT AS gROUP 1
CAR SEAT (FIg. 5).
ImPORTANT: IF yOU ADJUST ThE
bACKREST, ALwAyS mAKE SURE ThE
hARNESS IS wELL TIghT, AND IF
NECESSARy REPEAT ThE SAmE
OPERATION IN DIAgRAm 26.
27. HEAD HUGGER (OPTIONAL): this is
an accessory made to protect in a better
way smaller babies. Use it only with
harnesses in the lower position.
WASHING INSTRUCTIONS:
28. Release the harness from the buckle,
remove from the rear metal plate the
harness. Remove the harness from the
slots. Remove the fabric cover.
All fabric parts can be hand washed in
warm water (max 30 °C) with mild
detergent. Do not bleach. Do not tumble
dry. Do not dry clean. Do not iron.
To clean plastic or metal parts just use a
damp cloth. Do not use abrasive
detergents or solvents. Do not lubricate
removable parts.
28. SPARE PARTS:
THIS PRODUCT COMPLIES WITH
SAFETY REQUIREMENTS
1 139/1
Fabric cover for car seat
2 139/2 harnesses
3 139/3 Polystyrene left and
right
4 139/4
Chest pads
6 139/6
head hugger (optional)
7 139/7 instruction leaflet
8 139/8 plastic stopper
N CODE DESCRIPTION