1
INSTALLATION INSTRUCTIONS
SEAT HEATER KIT
AUTHR2000
Introduction
Your new Autoloc® seat heater kit can
transform nearly any automobile, boat,
truck, or RV seat into a comfortable throne
of warmth. No longer will cold weather be
so uncomfortable. Installation of the
AUTHR2000 Seat Heater Kit can be
performed with the simplest of household
tools by even the ‘weekend’ mechanic in
the seats of your choice for use with any
12 volt system capable of supplying 10
amps continuously. Please read the
following notes before beginning
installation.
• All instructions MUST be followed closely. Inability to do so will void warranty and could
cause damage to seats, vehicle or people.
• The width of the heating elements must not be changed by cutting or folding. Seats must have
a minimum of 11 inches of width between bolsters.
• The wiring harness must allow for full range of motion of the vehicle’s seat adjustment and
must not intrude with either driver or passenger leg & foot space.
• Great care must be taken on cars with side airbags. Only attach heating element to center of
seat, and NEVER connect power to any airbag connections during seat heater installation.
• Only wiring harnesses and components that came with the AUTHR2000 should be used. Do
not substitute any parts.
• Before installation in your seat, connect power to seat heater elements for 45 minutes to
allow for material outgassing. A slight odor will be noticeable, and may be noticeable for the
first few times the heaters are used after installation. This is normal and will subside.
Important Notes
