Caltech Calaer 2 kW, Installation Manual

Page: 40 / 60

12. Fuel system
38
For the installation of the fuel standpipe cut a hole of 25mm (1 inch) for
connector fitting. Make sure that no metal threads get into the fuel tank
while drilling. Cut the fuel pipe into length and remove any shreds of metal
from the end. Tilt the pipe to the side to be able to get it into the fuel tank
and fasten with the connector. Fasten the fuel line to the standpipe with a
provided rubber line and clamps.
12.3 Fuel pump and fuel filter
The possible positions of the fuel pump are determined by the location of
the heater and the fuel tank.
The pump must be installed with a fuel line maximum length of 1.2meters
(78
inch) from the fuel tank and no more than 8.8 meters from the heater
unit. The fuel pump must also be positioned in such a way that it is not more
than 1 meter (39
inch) above the minimum fuel level and 1 meter (39 inch)
below the maximum fuel level in the tank.
Caution!
Caution when handling fuel!

Turn off the heater before refueling and doing any kind of work on
the heater.

Do not inhale fuel vapors.

Avoid contact with the skin.

Do not smoke

No open flames when handling fuel.

Mixtures of used oil are NOT allowed!