Gazebo Owner’s Manual
NOTE: The following steps deal with Figure 12.
1.
Take each roof section and place side-by-side. Make sure the cross-beams are exposed and facing
each other. There are pre-drilled holes at each end of the roof sections; make sure these holes line up.
2.
Place one bolt with one washer and slide into pre-drilled hole. Place a nut and washer on the other
end of the bolt and tighten.
3.
Begin placing single-sided composition shingles on the bottom of the roof and nail into place. Then
place double composition shingles directly over single shingles. Repeat this process until both sides
are completely done.
4.
Place the last shingle in the middle of the two piece roof and nail into place.
NOTE: It is advised that all electrical connections be made by a licensed electrician. Some sauna models
are 220V. Check with your dealer to make sure what your sauna is.
Figure 12. OD-200 assembly
Page 21
Assembling Your Sauna
12/17/04
www.calspas.com
