^MAPP
Configure NAT translation
This command can be used to configure the cellular routers NAT table.
Default:
N/A
Storage:
&W
Command values:
^MAPP
=
<source IP address>,<incoming port number>,<destination IP
address>,<destination port number>
Where:
<source IP address>
IP address of remote client
<incoming port number>
incoming port number
<destination IP address>
IP address
<destination port number> destination
port
number
The cellular router’s NAT function can be used to forward incoming TCP
connections or UDP datagrams to an alternative IP address and port number.
The <source IP address> parameter may be set to 0.0.0.0 to accept connections from
ANY host otherwise this translation will only apply to connections from the
specified host.
The <incoming port number> parameter specifies the port number that the cellular
router listens or accepts datagrams on.
The <destination IP address> parameter specifies the IP address to redirect
connections/datagrams to.
The < destination port number > parameter specifies the port number to redirect
connections/datagrams to.
^MAPP?
Queries NAT configuration
CDM800 Series V.250 Manual
Page 27 of 33
To suit software version 1.52.2
4/4/2008
