LAN Configuration commands
The commands below are used to configure the Ethernet LAN interface. There is no error
checking beyond octet validation (Four octets of 0-255) for any of the Ethernet address
assignments. E.g. If you set the netmask to an invalid address, the modem will accept it but
may unable to transfer via the LAN interface.
^ETHI
Set the LAN Ethernet IP address
This command will set the LAN interface IP address.
Default:
192.168.1.50
Storage:
&W
Command values:
^
ETHI
=
<IP Address>
Sets the Ethernet IP.
^
ETHI?
Queries the current Ethernet IP.
^ETHN
Set the local Ethernet Mask
This command will set the LAN interface IP netmask.
Default:
255.255.255.0
Storage:
&W
Command values:
^
ETHN
=
<netmask>
Sets the Ethernet mask.
^
ETHN?
Queries the current Ethernet mask.
^ETHR
Print the Route Table
This command will print a copy of the modem’s routing table.
Default:
N/A
Storage:
N/A
Command values:
^
ETHR?
Prints
the
modem’s
routing
table
CDM800 Series V.250 Manual
Page 24 of 33
To suit software version 1.52.2
4/4/2008
