Features
Dual Gates Setup - Master/Slave
This setup is for dual
swing
gates. A single button press of the remote control can open both gates.
This requires 2 s
wing
gate operators. One gate operator is the "Master", and the other is the "Slave".
1. On the SLAVE gate operator circuit board, set dip switch #5 to ON
(Figure 1)
.
2. Press the reset button on the SLAVE gate operator circuit board.
3. A 20 awg cable (or higher gauge) with two
conductors
is required.
A.
Locate the green terminal
(Figure 2)
on the
bottom of the
circuit
board with the words DATA- and DATA+.
B.
Use a flathead screwdriver to release the 2 locks on the top of the green terminal.
C.
For
conductor
1, connect the
DATA
+ on the MASTER circuit board to the
DATA
+ on the SLAVE circuit board.
D.
For
conductor
2, connect the
DATA
- on the MASTER circuit board to the
DATA
- on the SLAVE circuit board.
E. Use the flathead screwdriver to close the two locks on the top of the green terminal.
4. Place the cable underground in an electrical conduit.
5. Make sure all remote controls, photosensors, loop detectors, and any other accessories are installed
on the MASTER
gate operator
, and not the SLAVE.
The setup is now complete
.
Figure 2
Figure 1
11