CalderaSpas paradise series, Owner'S Manual

Page: 19 / 40

Your spa comes equipped with a control panel located on the bartop above the equipment compartment door. The control panel allows the
user to set the temperature, activate the jets and lights, and access menus to lock the temperature and/or spa functions, and uses indicator
lights and an integrated LCD display to provide a quick visual check of the spa's status.
COnTrOl Panel BuTTOns anD DIsPlaY
Your spa control system consists of an illuminated Light Emitting Diode (LED) display and convenient push buttons that allow you to set the water temperature, as well as
the hydrotherapy jets, mood lighting, and optional jets from the spa control panel.
DIsPlaY InVersIOn
You may invert the control panel display for easier viewing from inside the hot tub.
To invert the display the following is required:
Press the “MODE

” & “OFF

” buttons simultaneously. By pressing the “MODE

” & “OFF

” buttons simultaneously a second time the screen will go back to it’s
original display.
TeMPeraTure COnTrOl
The set temperature range is from 80°F (26°C ) to 104°F (40°C). The set temperature of the spa water will automatically be 100°F (38°C) the first
time power is applied. This is the setting programmed at the factory. After the spa has been set up and used, the last temperature value set by the
user will be stored in memory. If power is disconnected from the spa, it will automatically revert to the last set temperature when power is reapplied.
(Temperatures of any setting may rise slightly depending on the current use and condition of your spa and on outside temperature.)
To display the set temperature of the spa, press the "ON ▲" button. The set temperature will be displayed, unless the spa is locked (in which case the lock icon is
displayed). The set temperature display will automatically return to actual temperature after five seconds. To increase the set temperature of the spa water, press the
"ON ▲" button. Each time the button is pressed, the set temperature display will increment by one degree. If the button is held down, the set temperature display will
increase by one degree every half-second.
To decrease the set temperature of the spa water, press the "OFF ▼" button. Each time the button is pressed, the set temperature display will decrement by one degree.
If the button is held down, the set temperature display will decrease by one degree every half-second.
If the set temperature value will not change, check the TEMP LOCK and SPA LOCK features. When either of these features is applied, the temperature control is
disabled.
17
OPERATING INSTRUCTIONS
COnTrOl Panel
MODE
UP Button
MODE
DOWN Button
OFF
DOWN Button
ON
UP Button
JETS Button LIGHTS Button