Page 31
Installation
SPA COVER INSTALLATION
1. Place the cover squarely on the spa.
2. Position the tie-down locks included with your cover on the
side of the spa so that they are easily reached by the cover
tie-down straps. Allow for about 1.5 - 2 cm (1/2” to 3/4”) slack
in the straps to make it easy to insert straps into locks and to
compensate for vinyl shrinkage in cold weather.
3. Attach the locks with the screws provided and insert the cover
tie-down straps into the locks.
NOTE:
Keeping the cover in place any time the spa is not in use will
reduce the amount of time the heater operates, thereby minimizing
operating costs.
Your
CALDERA
spa has been thoroughly tested during the
manufacturing process to ensure reliability and long-term customer
satisfaction. A small amount of water may have remained in the
plumbing after testing and, as a result, may have spotted the spa shell
or the spa siding prior to delivery. Before filling the spa, wipe the spa
shell clean with a soft rag. The following instructions must be read and
followed exactly to ensure a successful start-up or refill.
DELIVERY ACCESS
NOTE: It may be necessary to allow for additional over-head clearance if the spa
will be rolled up or down an incline or moved up or down a short flight of stairs.
Use the information in the chart on the next page to determine the requirements
for access to your desired location. It may be necessary to remove a gate, part
of a fence, or other movable obstructions in order to roll the spa to its installation
site. About ten percent of the time, a crane is the only way to install the spa by
lifting it to its final destination.
If the spa has to be taken off of the cart to go over a wall (either because the
entry area is too narrow, the eaves are too low, the corner is too tight, or the
stairway is too steep), a crane will be required. Don’t be alarmed!
The crane has a truck-mounted boom which can fit right in your driveway. It is run
by a licensed and insured operator.
For a charge, the crane operator will
lift your spa over walls, buildings,
or any other obstruction and place
it as close to the installation site
as possible. The
CALDERA
spa
delivery personnel will supervise the
crane delivery and complete the spa
installation. Crane delivery typically
takes an average of 30 minutes to
complete.
NOTE
: If your spa delivery requires
the use of a crane, you may be
required to pay for its services at the
completion of the delivery.
COVER INSTALLATION
TIE-DOWN
STRAP
LOCK
COVER
KEY
SCREWS (2)
DANGER. RISK OF INJURY.
• Never leave a spa uncovered or unattended.
• Never leave a spa cover unlocked.
• Do not stand, sit, or lie on the cover.
SPA DIMENSIONS
Model
Width (W) Length (L) Height (H)
MAKENA
91 cm (36")
226 cm (7'5")
226 cm (7'5")
SALINA
91 cm (36")
226 cm (7'5")
226 cm (7'5")
MARTINIQUE
88 cm (34")
226 cm (7'5")
193 cm (6'4")
SEYCHELLES
91 cm (36")
213 cm (7'0")
213 cm (7'0")
REUNION
91 cm (36")
213 cm (7'0")
213 cm (7'0")
KAUAI
75 cm (29.5")
213 cm (7'0")
165 cm (5'5")
How is your width and height clearance?
Protruding electric meters
A/C units
Do you have sufficient
overhead clearance?
Check low roof eaves,
overhanging branches,
rain gutters
Is the path clear?
Move away branches, dog
houses, firewood, etc.
If there is a 90 turn, can we
clear it? (The spa will not bend.)
No more than 6 consecutive
stairs without a landing
to accommodate the spa
Gas meters
Check all gates
HOUSE
BACK YARD
STREET
How is your width & height clearance?
Check all gates
Protruding electric meters
Gas Meters
A/C units
Do you have sufficient
overhead clearance?
Check low roof eaves,
overhanging branches,
rain gutters
Is the path clear?
Move away branches, dog
house, firewood, etc.
if there is a 90 turn, can we
clear it? (the spa will not bend)
No more than 6 consecutive
stairs without a landing to
accommodate the spa
230V WIRING ACCESS
OPENINGS ON RIGHT & LEFT HAND SIDE BELOW CORNER
DOOR
DRAIN
POWER CONNECTION ACCESS
