Spa Care and Maintenance
Page 27
gallons) of spa water into the filter compartment. This is twice the
normal amount of chlorine needed for superclorination. This extra
amount of chlorine is needed to destroy the anti-freeze.
NOTE:
A defoamer may be needed to decrease the amount of
foam caused by the anti-freeze.
4. Drain your spa to ensure removal of anti-freeze. Do not drain water
on grass or plants due to excessive chlorine level.
5. After the spa has completely drained, re-install your filter and
follow the Start-up Procedures in the Getting Started section of the
Owner’s Manual.
IMPORTANT:
Always keep spa covered when not in use, whether it
is empty or full.
CARE OF THE SPA PILLOWS
The spa pillows will provide years of comfort if treated with care. They
have been positioned above the water level to minimize the bleaching
effects of chlorinated water and other spa water chemicals. To extend
their life, whenever the spa shell is being cleaned, the spa pillows should
be removed and cleaned. Body oils can be removed with a mild soap
and water solution. ALWAYS rinse off the spa pillows thoroughly to
remove any soap residue. If the spa is not going to be used for a long
period of time (that is during a vacation or if the spa is winterized), or
when the spa water is being super-chlorinated, the spa pillows should be
removed until the next use of the spa.
TO REMOVE AND REPLACE THE SPA
PILLOWS:
1. Carefully lift one end of the pillow away from the spa shell.
2. Continue lifting one end until all pillow retainers are released from the
pillow.
IMPORTANT
: Just pulling the pillow straight up and out of the shell
recess will eventually damage the pillow. This abuse is not covered
under warranty.
3. To reinstall the spa pillow, carefully bend the pillow slightly to allow
one of the pillow retainers to slip into the recess in the back of the
pillow.
4. Keeping the pillow slightly bent, slide the other pillow retainer into the
recess in the back of the pillow.
5. After all the pillow retainers are in place, press the pillow down into
the recess in the spa shell.
CARE OF THE EXTERIOR
SPA SHELL
Your
CALDERA
spa has an acrylic shell. Stains and dirt generally will
not adhere to your spa’s surface. A soft rag or a nylon scrubber should
easily remove most dirt. Most household chemicals are harmful to your
spa’s shell. Always rinse off any spa shell cleaning agent with fresh
water.
SPA SKIRT
When cleaning the skirt of your spa, use only a soft cloth or sponge with
a mild soap and water solution. The use of an abrasive type cleaner or
applicator will be harmful to the exterior finish. Always thoroughly rinse
off the spa skirt with fresh water.
CARE OF THE SPA COVER
WARNING:
The cover is a manual safety cover that meets or
exceeds all prevailing requirements of ASTM Standards for spa safety
covers when installed and used correctly as of the date of manufacture.
Non-secured or improperly secured covers are a hazard. Open the cover
to its fully open position before use.
VINYL COVER
The vinyl spa cover is an attractive, durable foam insulation product.
Monthly cleaning and conditioning are recommended to maintain its
beauty.
TO CLEAN AND CONDITION THE VINYL
COVER:
1. Remove cover from the spa and gently lean it against a wall or fence.
2. With a garden hose, spray cover to loosen and rinse away dirt or debris.
3. Using a large sponge and/or a soft bristle brush and a very mild soap
solution (1 teaspoon dishwashing liquid with 7.5 liters [2 gallons] of
water) or baking soda (sodium bicarbonate), scrub the vinyl top in a
circular motion. Do not let the vinyl dry with a soap film on it before it
can be rinsed clean.
4. Scrub the cover’s perimeter and side flaps. Rinse clean with water.
5. Rinse off the underside of the cover with water only (don't use soap),
and wipe it clean with a dry rag.
6. Use
FRESHWATER
Cover Shield to protect the cover.
SERVICE NOTE:
To remove tree sap, use cigarette lighter fluid (not
charcoal lighter fluid). Use sparingly, and rinse with a saddle soap solution
immediately afterwards, then wipe dry.
IMPORTANT REMINDERS:
• DO
remove snow buildup to avoid breakage of the foam core from
the additional weight of the snow.
• DO
lock cover lock straps to secure the cover when the spa is not
in use.
• DO NOT
drag or lift the spa cover using either the flaps or the cover
lock straps.
• DO NOT
walk, stand, or sit on the cover.
• DO NOT
place any metal or heat transferring object on the cover
or place any type of plastic tarp or drop cloth over the cover as
this may result in a melted foam core, which would not be covered
under the warranty.
• DO NOT
use any lifting mechanisms, chemicals or cleaners except
those recommended by Watkins Wellness or its Authorized Sales
and Service Dealer.
Spa Care and Maintenance
