DOOR PANEL REMOVAL
*
1
Locate and remove the two screws on the
bottom of each corner on the front panel
(same side as the Control Panel)
*
2
Place door panel in position as illustrated to the left.
a. Raise door panel from bottom making sure all 4 door panel
plastic clips are behind the 4 spa plastic clips, this requires
the door panel to be behind the bar top.
b. Using both hands, push in the area where the metal clips
are located to snap the door panel metal clips into position.
c. Replace the 2 screws that were removed in step 1 of the
Door Panel Removal section.
Locate notch below panel on one side and center.
Placing fingers inside notches, pull panel slightly away
from spa only on side (not center).
Locate notch on other side of panel and place fingers
inside the notch and center notch. Pull panel away
from spa, lower panel and store in a cool and shaded
place.
NOTE:
It may be possible when pulling out the first
clip to pull the panel out too far releasing the second
clip.
Control Panel
Remove Screw
DOOR PANEL REPLACEMENT
*
1
In order to replace the panel, the illustration to
the right shows how the panel is held in place.
a. The 4 plastic clips attached to the top
back side of the door panel slide behind
the 4 plastic clips attached to the spa.
b. The 2 metal clips on the bottom of the
door snap into the 2 metal clips attached
to the bottom of the spa.
*
2
DOOR PANEL INSTRUCTIONS
The illustrations are to be used as a reference
only (your spa may look slightly different).
Remove Screw
Plastic
Clips
Metal
Clips
Door Panel
(Back Side)
Plastic
Clips
Metal
Clips
Bar
top
Notch
Notch
Notch
Page 40
Service Information
