Sauna Owner’s Manual
Figure 18. Stereo back plate
Antenna
1. Plug the antenna into the back of the stereo unit.
2. Mount the antenna underneath the bench with the provided screws.
The antenna can be mounted on the outside of the sauna. A hole must be drilled through the
wall. Route the antenna cable through the hole from the outside, then plug it into the stereo.
Make sure the hole is properly sealed afterwards.
Mounting the Speaker and Speaker Box
1. To mount the speaker box, place the L-bracket on the underside of the main bench and
attach the L-bracket using the provided screws (Figure 17).
2. Slide the speaker box up between the L-brackets and attach them with four screws through
the sides of the speaker box.
Wiring the Speakers
1. Run the provided speaker wire from the purple speaker plugs into the speaker located on the
left side of the stereo. Run these wires between the bench, the sauna wall, and through the
pre-drilled hole on the back of the speaker box (Figure 17).
2. Mount the speaker on the underside of the bench seat in the left corner.
3. Run the provided wire from the green speaker plugs into the speaker located on the right
side of the radio. Run these wires between the bench, the sauna wall, and through the pre-
drilled hole on the back of the speaker box.
4. Mount the speaker on the underside of the bench seat in the right corner.
5. Run the power cord under the main bench and plug it into the main junction box.
Page 53
Using the Stereo System
LTR20071007, Rev. A
Summary of Contents for Cal Heat CU-100
