Sauna Owner’s Manual
NOTE:
The following steps deal with Figure 13.
1. Take each roof section and place side-by-side. Make sure the cross-beams are exposed and
facing each other. There are pre-drilled holes at each end of the roof sections; make sure
these holes line up.
2. Place one bolt with one washer and slide into pre-drilled hole. Place a nut and washer on
the other end of the bolt and tighten.
3. Begin placing single-sided composition shingles on the bottom of the roof and nail into
place. Then place double composition shingles directly over single shingles. Repeat this
process until both sides are completely done.
4. Place the last shingle in the middle of the two piece roof and nail into place.
NOTE:
It is advised that all electrical connections be made by a licensed electrician. Some
sauna models are 220V. Check with your dealer to make sure what your sauna is.
Figure 13. OD-200 assembly
Light Installation (Both Inside/Outside)
1. Use the decorative light for the outside. Attach the black wires to each other and attach the
white wires to each other. Tuck the excess wires into the junction box and tighten the
mounting screws. A 100W light bulb is recommended for outside use.
2. Use the gray, commercial-grade light for the inside. Attach the black wires to each other and
attach the white wires to each other. Tuck the excess wires into the junction box and tighten
the mounting screws. A 60W soft-white light bulb is recommended for inside use.
Page 45
Assembling Your Sauna
LTR20071007, Rev. A
Summary of Contents for Cal Heat CU-100
