Cal Spas Cal Heat CU-100, Owner'S Manual

Page: 53 / 76

Sauna Owner’s Manual
Each time the button is depressed, the temperature will increase 5Þ, to a maximum of 130ÞF.
Setting the Time
1. Be sure the digital display is on and the LED indicator is off. The digital display indicates the
current temperature in the sauna. Press the ‘Time/Temp Set’ button. The last stored temperature
setting flashes on the digital display.
2. With the digital display flashing, press the ‘On/Off’ button. The last stored time-setting flashes on
the digital display.
3. With the digital display flashing, press the ‘Time/Temp Set’ button to decrease the time 5 minutes.
NOTE: Each time you press the button, the time will decrease 5 minutes.
4. To increase the time, wait 4 seconds until the display stops flashing; repeat Step 2 through Step 4.
NOTE: Each time you depress the button, the time will increase in five minute increments, to a
maximum of 60 minutes.
Turning the Infrared Heaters and Room Light On/Off
1. Pressing the ‘Heat/Light’ button once turns the heaters and the room light on.
2. Pressing the ‘Heat/Light’ button again turns the heaters and room light off.
Default Temperature: 120 degrees F
Default Time: 60 Minutes
High Limit Device
This system has a built-in high limit control, which automatically turns off the system if the
temperature inside the room rises to an abnormally high level. If the “OH” (overheated) appears
on the control screen, this indicates that the system overheated. To restart, let the system cool,
then press the ‘On/Off’ button on the control panel to reset the system.
Page 49
Operating Your Sauna
LTR20071007, Rev. A