Cal Spas Cal Heat CU-100, Owner'S Manual

Page: 55 / 76

Sauna Owner’s Manual
Pressing it again will resume the heating cycle.
Note: When the temperature reaches the set value, the temperature will remain constant and
the infrared heaters will heat continuously. When the set time is up, the beeper will give five
beeps to remind the user of the end of the sauna session.
By pressing the LMT CONTR (Limit Control) button, the system’s running time and temperature
will be locked and cannot be changed. Time counting and operation suspension will not be
possible. Pressing the LMT CONTR button a second time cancels the limited control and all
functionality will be restored. After the running time and temperature have been set, in order to
prevent tampering with the parameters or with the START/STOP button while the user is inside
the cabinet, use the LMT CONTR button on the inside of the cabinet.
Using the Vent Sashes
Pull out the two vent sashes to ventilate the air. During operation, if the user becomes
overheated, open the vent sashes on the upper part of the rear wall and on the front door for
ventilation. This will let in fresh air.
Adjusting the Height of the Front Infrared Heater
Hold the left and right sides of the heater and pull up or down to your desired height.
Operating the CD Player
To insert a CD, pull the drawer bar out of the CD player and push the cover switch sideways to
open the CD player cover. Press the button to play a CD. See the enclosed owner’s manual for
other CD operation controls.
Fault Conditions
When the temperature sensor detects a fault, the infrared heaters will shut off, the temperature
display will show “EE”, and the beeper will sound. To reset, switch the power off and then
switch it back on again. When the temperature detection is normal, the system will return to
standby condition. If the fault persists, call your Cal Heat dealer for service.
Page 51
Operating Your Sauna
LTR20071007, Rev. A