12
Step 4
Note: This step is com-
pleted at the factory. It
is only shown to illustrate how to complete the unit assembly.
1) Attach the Gas lines as shown in Figure C.
2) Slide Face Plate into the Griddle Body as Shown.
3)
Secure the face using 5/16” x 3/4” screws (4 ea.), 5/16” Flat
Washers (8 ea.) and 5/16” nuts (4 ea.). The Flat Washers should
be inside the Face Plate. Tighten the nuts and bolts securely.
Step 5
Note: The previous 3 steps should have been
completed at the factory. For general assembly
this step should be the final step after step 2.
1) Place Griddle Body onto the Pedestal/Skid
Assembly as shown. Using 5/16” x 1/2”
screws (4 ea.) secure the body to the skid.
Be sure to tighten the screw securely.
2) Slide the Grease Box onto the Mounting
Forks located on the right hand front below
the grease channel.
Face Plate
5/16” x 3/4” Screw
4 ea.
5/16” Large Washer
8 ea.
5/16” Nut
4 ea.
Figure C
