10
Step 5
Note: This step is completed at the factory. It is only shown to illustrate
how to complete the unit assembly.
1)
Attach Valve Control Box to the side of the Griddle Head using 5/16”
x 1/2” Screws (2 ea.) and 5/16” nuts (2 ea.). Screws should be posi-
tioned to the outside of the Griddle Head. Tighten Screws securely.
2) Place the Face Plate onto the Griddle Head as shown. Bolt to the
Griddle Head using 5/16” x 3/4” Screws (3 ea.), 5/16” Washers (6 ea.)
and 5/16” Nuts (3 ea.). The Screws should be placed the to outside
of the Griddle Head with the washers and nut to the inside. Tighten
the fasteners to finish this step.
Step 6
Note: The previous 3 steps should
have been completed at the factory.
For general assembly this step should
be the final step after step 2.
1) Place the completed Griddle Head
Assembly on to the top on the Skid
and Pedestal Assembly. Align the
hole in the top of the pedestal with
the threaded hole in to bottom of
the Griddle Head and fasten using
5/16” x 3/4” Bolts. Tighten Bolts to
complete the assembly.
2) Slide the Grease Box onto the
Mounting Forks located on the
right hand front below the grease
channel.
Face Plate
Control Box
5/16” x 3/4” Screw
3 ea.
5/16” Large Washer
6 ea.
5/16” x 1/2” Screw
2 ea.
5/16” Nut
5 ea.
