3 / LIQUIDS
This plant must be protected from splashes. Make sure that no container containing
liquid is placed on or above the Central and that no other person do not spill liquid or
splashes Central.
4 / CLEANING
Unplug the power before cleaning. Use only a damp cloth (no solvents).
5 / VENTILATION
To ensure adequate air circulation and avoid overheating, the vents on the hood must
not be obstructed. The station must not be installed in an airtight area. It should be
placed on the unit other electronic or heat-producing products.
6 / ACCESSORIES
The use of accessories not built by the manufacturer may damage the plant.
7 / ANTENNA CONNECTION
Before connecting or disconnecting the antenna cables, the plant must be
disconnected from the sector.
Please note maximum levels of output on the product and not to exceed. In doubt,
lower the faders to minimum before connecting the antennas.
If these recommendations are not applied, the antenna, the Central as well as any
other equipment connected to the distribution network could be damaged.
8. CONNECTION TO THE DISTRIBUTION NETWORK
Disconnect the power plant sector before connecting or disconnecting the cable
distribution network. If these recommendations are not followed, the Central as well as
any other equipment connected to the distribution system may be damaged.
9 / THE MASS
The binding of the chassis to earth shall be made according to the standard EN 50083-
1
10 / CENTRAL LOCATION
The control unit must be installed in a flat and well protected place away from direct light
from the Sun. Everything must be implemented to avoid sunny and humid places.
Do not install the unit near radiators or other heat-generating products.
Make sure that the plant is less than 10 cm from any other equipment of
electromagnetic influence.
To ensure adequate air circulation and avoid overheating, the vents on the hood must
12
