TOTAL LITE Revision 1
SERVICE MANUAL FOR INNOVATION
TOTAL LITE
Single-Cup Brewer
28
6.7
System Screen
To get to the screen below press the setup (white) button (SW1 as shown in section 4.7) on the main
board inside the door of the machine and press the SYSTEM tab.
6.7.1 System 1 tab
1. This button is used to set the language of the system. To change the language select which
language you want then press SAVE ALL. A window will pop-up and tell you what to do. Note
that if the language is changed, the name of the products will be reset.
2. This button is used to set the number of coffees before showing the waste bin full message on the
selection screen. Disable the waste bin full message feature by putting this counter to zero.
3. This button is used to set the number of drinks made before showing rinse needed message on the
selection screen. Disable this feature by putting the counter to zero.
4. This button is used to set the water temperature in the tank in Fahrenheit.
5. This button is used to set the minimum temperature of the water in the tank. If the water temperature
drops below this setting, the coffee brewer will show an error until the temperature rises above
this temperature.
6. This table is used to set the labels that will be shown under the size buttons on the selection screen.
7. These buttons are used to enable or disable each size of coffee cups. If only one size is available,
the size selection screen will be skipped in the drink selection process.
8. This button is used to reset the system back to factory settings.
9. TO SAVE any parameters change press this button.
1.
2.
3.
4.
5.
8.
6.
7.
9.
Service Software
