TOTAL LITE Revision 1
SERVICE MANUAL FOR INNOVATION
TOTAL LITE
Single-Cup Brewer
63
10.2 Shutdown / Storage
If you need to store this brewing equipment for an extended period of time, follow this procedure to
avoid any risk of injury or damage to the equipment.
1. Turn the unit off and unplug from the power outlet;
2. Drain the hot water tank (see instructions see section 10.1);
3. Empty the soluble canisters and the 3 bean canister;
4. Clean all parts of the unit before storing (see cleaning instructions see section 8)
5. Disconnect the white wire from the heating element (see installation diagram see section 9.3)
6. Tie down the water level switch’s arm with a twist tie to keep the float from pulling down on the
switch during transportation. “
Do not overtighten
”, this may damage the switch; this is simply to
keep the float from bouncing up and down on the switch.
10.2.1 Storing the Brewer Assembly
The brewer assembly is the heart of the equipment and is responsible for the taste of the coffee.
It is therefore important that you store it properly when it is not in the unit. Always disengage your
brewer clutch by using a pair of pliers and turning the pin located on the back clockwise until the brew
chamber lifts up. This will release the pressure on the screen and seal. Your brewer must be on its
back or its left side while on a table top. Do not sit the brewer on its right side (wheels and yoke) or
straight up as these positions are not sturdy and could cause it to fall.
Servicing Parts
