REGUL8OR – User’s Manual
18
Update Mode
The current or voltage setting of the unit can also be performed in four different
modes:
•
NORMAL
: the update of the set-point (current or voltage, depending on the
operation mode – i.e. CC or CV respectively) is performed as soon as a new
set-point is received via the remote, local or fast interfaces
•
WAVEFORM
: the update of the set-point is performed on a specific timing
(defined as a “waveform” attribute, more information on the
Waveform
section) and it is done internally
•
TRIGGER
: the set-point is updated by an external event – i.e. a hardware
trigger coming from the rear BNC connector
•
ANALOG INPUT
: the unit is controlled by an external signal that is fed to
the rear BNC connector. The unit acts as a C.C. or C.V. controller depending
on the pre-set Regulation Mode
