Cadillac 2010 CTS, Owner'S Manual

Page: 145 / 464

Instruments and Controls 4-35
information button again until the
DIC displays Rear Tire PSI (kPa)
Left ## Right ##.
If a low tire pressure condition is
detected by the system while
driving, a message advising you to
add air to a specific tire appears in
the display. See
Tire Pressure on
page 9 ‑ 66 and Tire Messages on
page 4 ‑ 48 for more information.
Battery Voltage
This display shows the current
battery voltage. The vehicle's
charging system regulates voltage
based on the state of the battery.
The battery voltage may fluctuate
when viewing this information on the
DIC. This is normal.
If there is a problem with the battery
charging system, the charging
system light illuminates and/or the
DIC displays a message. See
Charging System Light on
page 4
‑ 23 , Battery Voltage and
Charging Messages on page 4 ‑ 37
and Battery Load Management on
page 5 ‑ 6 for more information.
Calibrate Compass
The vehicle may have this feature.
The compass can be manually
calibrated. To calibrate the compass
through the DIC, see
“ DIC
Compass ” later in this section.
Change Compass Zone
The vehicle may have this feature.
To change the compass zone
through the DIC, see
“ DIC
Compass ” later in this section.
Relearn Remote Key
If the vehicle has the Remote
Keyless Entry (RKE) system, this
display allows you to match the
transmitter to the vehicle. This
procedure will erase all previously
learned transmitters. Therefore, they
must be relearned as additional
transmitters.
If the vehicle has the keyless
access system, see the Keyless
Access information for
Remote
Keyless Entry (RKE) System
Operation (Key Access) on
page 1
‑ 5 or Remote Keyless Entry
(RKE) System Operation (Keyless
Access) on page 1
‑ 7 for
instructions on matching a keyless
access transmitter to the vehicle.
To match an RKE transmitter to the
vehicle:
1. Press the vehicle information
button until Press To Relearn
Remote Key displays.
2. Press the set/reset button until
Remote Key Learning Active is
displayed.
3. Press and hold the lock and
unlock buttons on the first
transmitter at the same time for
about 15 seconds.
On vehicles with memory recall
seats, the first transmitter
learned will match driver 1 and
the second will match driver 2.
A chime sounds indicating that
the transmitter is matched.