Page 14
509 Sharptown Road P.O. Box 345 Bridgeport, NJ 08014
Email: [email protected] Fax: 856-467-5511
Internet: http://caddycorp.com Phone: 856-467-4222
8.
As weld cools use a clean, dry cloth to wipe excess material from the hot tip.
CLEAN HEATING TIP
BETWEEN EVERY WELD. DO NOT SCRATCH ITS TEFLON COATING.
9.
After approximately five minutes, remove the belt from the welder.
10.
Using the special flat-edged flash cutters
T
, trim excess material from around the weld area.
NOTE:
These flash cutters are not standard diagonal cutters and should only be used for trimming the belt.
NOTE:
Should the use of a Belt Tool become necessary, the Overlapping Belt Splicing Tool is available from Caddy
Corporation.
Note:
This 21-C Conveyor is not designed to convey Bus Boxes/Tote Boxes.
Note:
The 21-C Conveyor is designed and fabricated for your specified tray size.
