CM-MD64_24-05-2023_Iss-1.docx
Page. 16 / 31
6.
IO FS:
Indicates the sample rate (FS) of the inputs and outputs.
7.
WC
: Word Clock status.
EXT-LED
indicates the unit is set to follow an external clock;
INT-LED
shows the unit is set to CM-
MD64’s internal clock. For more information refer to the section:
Front Panel Dip Switch Settings
8.
SYNC
:
Synchronisation status. The
WC-LED
indicates the unit is FOLLOWING a Word Clock
connected to the
Word Clock IN
BNC [9]. The
MADI-LED
indicates the unit is FOLLOWING a
Word Clock set by a third-party unit within MADI network that is connected to the
MADI Ports
[2]. If both LEDS are OFF, the CM-MD64 is acting as the Word Clock for the network.
9.
Word Clock IN / Word Clock OUT:
Word Clock IN or OUT - on BNC connectors for 75 ohm
co-axial cable - to ensure the synchronisation of the digital signal with the network.
10.
75 ohm switch
: The recessed switch is the input termination for the Word Clock. When
pressed the impedance is set at 75 ohm for use with 75 ohm coax cable.
11.
Network
: RJ45 Ethernet port f
or updating the unit’s firmware. This is a standard PC network
Gigabit Ethernet port.
12.
PSU indicators
: LEDs indicate the ON status of each of the two internal power supplies.