1
2010 POWERDRIVE IDS CONTROL SYSTEM USER MANUAL
LINE LENGTH CORRECTIONS
The steering adjustments are made at the end of the fl ying
lines where they are connected to the kite.
If one of the fl ying lines is too long, loosen the larks head
loop from the knot, then loosen the knot and move it towards
the kite to shorten the line.
If the line is too short, loosen the larks head loop from the
knot, then loosen the knot and move it towards the control
bar to lengthen the line.
Front fl ying lines can be adjusted with the center leader
line located immediately above the Centerline Adjustment
Strap (CAS). Length adjustments here are performed us-
ing the same technique as described above for the outside
steering lines.
• Re-tighten the knot and check your line length again. Ad-
just again if necessary until the control bar is balanced.
• DO NOT put knots in your FLYING LINES. Knots in the
fl ying lines compromise the life of the line.
INCORRECT
If your bar is at an
angle, your leader line
needs adjustments.
2
CORRECT
Control bar is even
and parallel with your
shoulders
1
SETUP
Powerdrive_IDSX_ENG_final.indd 12
28/3/09 5:49:23 PM
