Chapter 2: Installation
2-4
HSIM-A6DP User’s Guide
2.3
INSTALLING AN HSIM
You can install an HSIM in any Cabletron Systems device that supports
HSIM technology (e.g., 2E42-27, 6E132-25). Refer to the release notes
for the version of firmware running on the Cabletron Systems device to
ensure that the HSIM-A6DP is supported. The following subsections
provide generic instructions for installing an HSIM-A6DP in a module or
in a standalone hub.
2.3.1
Installing an HSIM in an Interface Module
To install an HSIM-A6DP in a module that supports HSIM technology:
1.
Disconnect all cables from the interface module. Note the ports to
which these cables attach.
2.
Attach the antistatic wrist strap (refer to the instructions outlined on
the antistatic wrist strap package).
3.
Unlock the top and bottom plastic locking tabs of the module
faceplate.
4.
Slide out the module, and place it on its side with the internal
components facing up.
5.
Remove and save the two faceplate mounting screws securing the
HSIM coverplate and remove the coverplate. See
Figure 2-3
.
6.
Remove and save the two standoff screws. See
Figure 2-3
.
Only qualified personnel should install or service this unit.
Summary of Contents for HSIM HSIM-A6DP-
