Cabletron Systems CSMIM-T1, Installation Manual

Page: 59 / 198

Commands
CSMIM-T1 Hardware Installation Guide 3-17
3.2.10 mop
The mop command sets the MOP load/dump address. This is useful when
the loading the CSMIM-T1’s operational image from a VAX VMS load
host. The command syntax is:
mop [–d]
The mop command display looks like this:
The
mop –d
command displays the current MOP settings:
3.2.11 net
The net command executes an Ethernet transceiver loopback test on the
local area network. The command syntax is:
net
The net command display looks like this:
This transciever loopback test sends out a short test packet from the
CSMIM-T1 through the MicroMMAC to test the integrity of the network.
One of the Ethernet connections (internal AUI or external connection)
must be valid for this test to pass.
monitor:: mop
Enter preferred MOP load/dump address [<uninitialized>]::
Load Broadcast Y/N [Y]::
monitor:: mop -d
MOP preferred load/dump address <uninitialized>
Load Broadcast: Y
monitor:: net
Network test – PASSED