Cablescan 128/PC, Instruction Manual

Page: 37 / 59

Model 128/PC Instruction Manual Page 29
Learn - LG
This command is the same as the LEARN key on the front panel. It is used to create a wire list
program automatically by scanning a connected harness assembly and storing the continuities in
the Test Memory. The learned program overwrites the program that is in the Test Memory. If
the program in the Test Memory has not been saved and is to be used later, use the Save Program
command before running Learn.
Load Program - LI
This command is the same as Load Program selected from the Menu. Use the Load Program
command to load a stored program from the Program Memory into the Test Memory. When the
LI command is typed followed by an ENTER, the signature of one of the programs in memory is
displayed. Press the letter D to advance down the list of programs, or press the letter U to
advance up the list. The next program signature will display each time the letter is pressed. To
load the program corresponding to the displayed signature, press ENTER.
Save Program - SI
This command is the same as Save Program selected from the Menu. The Save Program
command is used to copy the program currently in the Test Memory into the Program Memory.
If there is insufficient Program Memory to store the wire list,
Memory Full is displayed. If
there is sufficient Program Memory, prompt Are you sure? is displayed. To save the program,
press the letter Y.