background image

UNPACKING 

1

After opening the top carton flaps, remove the grille. then fold 
the carton flaps right back and invert the carton contents. Lift the 
carton clear of the contents and remove the inner packaging from 
the speakers. We suggest you to retain the packing for future use.

POSITIONING

Speakers positioning

Our speakers have been designed to function in a vertical posi-
tion. under these conditions, the polar response is most uniform. 
the majority of our models are delivered with a set of decoupling 
spikes or cones

2

, these accessories are to be screwed in the in-

serts under the cabinets. these accessories ensure the stability of 
the speaker while limiting resonance coming from certain types of 
grounds like wood floors.
Speakers are delivered with a front grille to protect drivers. 
It is possible to use them without this front grille, by gently 
pulling its top end in order to cut off its magnetic link with 
the magnets to the front panel.  to get the grill back in place, 
position it in front of the speaker and approach it to the front 
panel until the magnetic link is effective. these operations 
must be carried out very smoothly in order not to damage 
prematurely the veneer covering the magnets on the front pa-
nel of the speaker. We recommend this protection to be kept 
on to prevent accidental damage to the drivers

3

.

Powerful drivers generate magnetic fields that can extend 
beyond the boundaries of the speaker cabinet. We recom-
mend you keep magnetically sensitive articles (tV, computer 
screen, computer discs, audio and video tapes, swipe cards...) 
at least 1.5 ft (50 cm) away from the speaker. Cabasse centre 
speakers or the ones marked «tV» are not concerned with 
this, being magnetically shielded.

Positioning speakers in a room

In addition to vertical position of the speakers themselves, 
their location in the listening room, as well as the acoustical 
characteristics of the room, are also very important. As it is 
impossible to indicate a typical location of speaker systems 
without a few tests, we suggest several general rules that are 
important to apply in order to obtain the best listening results.

Optimal positioning for a 2.0 or stereo system 

4

  For the ideal positioning of your speakers follow the diagram 

4

 on page 2. If «d» is the distance between the two 

speakers, this distance must be equal to or  higher than 5 ft 
(1.5 m). Both speakers must be at equal distance from the 
listening area which forms with them an isosceles triangle. 
«d1» and «d2»distances must be identical, they should be 
equal to or longer than «d».

  the drivers must be directed towards the listening area.
  the speakers should be located so that their diffusion fol-

lows the longest dimension of the room.

  generally speaking it is better to avoid putting the speakers 

in the corners of a room as this amplifies the low frequencies 
and tends to enhance the room resonances. If possible it is 
better to place the speakers at least 8 inches (20 cm) from 
the walls.

  Moreover, in order to obtain a more accurate frequency res-

ponse, it is recommended to raise a compact speaker from 
12 to 16 inches (30 to 40 cm) above the floor by placing 
them on stands. the tweeters of the speakers must be rou-
ghly at the same height of the listener’s ear when the listener 
is in sitting position.

  No solid object or piece of furniture should be placed 

between the speakers and the listener. An effect of mask, 
even partial disturbs completely the sound reproduction as 
it attenuates the high frequencies and also, in most cases, 
the midrange frequencies.

  Placing the speakers in niches is not recommended. unless 

designed for this application, bookshelf placement will alter 
the frequency response of the speaker, especially in the low 
frequencies. If a bookshelf location cannot be avoid, the 
speaker should be set up to minimize various resonance, 
and the visible part of the grille must be outside the niche.

Optimal positioning for a 2.1 or stereo with a 

subwoofer system

5

For a stereo listening with 2 speakers or 2 satellites and 1 
subwoofer, we recommend you to place the subwoofer in the 
front listening area. the placement of the subwoofer against 
a wall reinforces the low frequencies and limit the reflections 
from 80 to 200 hz. however to obtain the best results, it is 
always necessary to carry out tests according to the acoustic 
of the room.

Optimal positioning for a 5.1

or home theatre system

6

 

Setting up a multi-channel Audio-Video system requires great 
care when positioning the specific AV speakers.

  the centre speaker should be placed as close as possible 

to the screen and where it sounds best from your listening 
spot while offering the optimal picture/dialogues cohesion. 
theoretically, the screen should be located within a virtual 
triangle formed by the acoustical centres of the main spea-
kers and the centre speaker. Practically speaking, this means 
that the principal speaker should be placed above the screen 
if the main speakers are below it, and below the screen if the 
main speakers are above. the centre speaker should also, 
if possible, be set slightly back from the others, so that it is 
located at the same distance from the listener as the main 
speakers.

  the rear speakers or surround should be placed against the 

side walls, at listening height. they should not be positioned 
far behind the listening zone.

  the subwoofer should be placed in the front listening area, 

its position against a wall reinforces the extreme low register 
and limits the reflections between 80 and 200 hz. however 
to obtain the best result, it is always necessary to carry out 
tests according to the acoustics of the room.

Your AV processor enables the adjustment in level and delay 
of each of the 5/6/7 channels of your system. Fine-tuning is 
necessary to obtain a perfect sound stage.
turn off all the amplifiers before interconnecting them to the 
loudspeakers. In order to connect loudspeakers properly, it 
is most important to keep in mind the following two factors: 
cable section and phase.

CONNECTION

Cable section

to get the full sonic 
potential of Cabasse 
loudspeakers and 
avoid power losses, 
the cables connec-
ting the speakers to the power amplifier must have the lowest 
possible electrical resistance. to help you in choosing the cor-
rect cable gauge, follow diagram.

     Lenght between 

recommanded

amplifier and loudspeaker

              section

 

4,5 m 

  1,5 mm

2

 

6 m 

  2 mm

2

 

7,5 m 

  2,5 mm

2

 

9 m 

  3 mm

2

 

12 m 

  4 mm

2

Summary of Contents for SOCOA MT32/2


















Reviews: