background image

UNPACKING 

After opening the top carton flaps, fold the carton flaps right 
back, remove the cardboard sheet, the bag of accessories 
and the foam halfshells protecting the speakers and the front 
grille. Then pull out the grill and the speaker. We suggest you 
to retain the packing for future use.

POSITIONING

Speakers positioning

Our speakers have been designed to function in a vertical 
position. Under these conditions, the polar response is most 
uniform

1

.

The Jersey model is delivered with a set of decoupling spikes

2

These accessories are to be screwed in the inserts on the base 
of the speakers. These accessories ensure the stability of the 
speaker while limiting resonance coming from certain types of 
grounds like wood floors.
Speakers are delivered with a front grille to protect drivers. It is 
possible to use them without this front grille, by gently pulling 
its top end in order to cut off its magnetic link with the magnets 
to the front panel. To get the grill back in place, position it in 
front of the speaker and approach it to the front panel until the 
magnetic link is effective. These operations must be carried out 
very smoothly in order not to damage prematurely the veneer 
covering the magnets on the front panel of the speaker

3

.

Powerful  drivers  generate  magnetic  fields  that  can  extend 
beyond the boundaries of the speaker cabinet. We recommend 
you keep magnetically sensitive articles (CRT TV, computer 
screen, computer discs, audio and video tapes, swipe cards...) 
at least 1.5 ft (50 cm) away from the speaker. 

Positioning speakers in a room

In addition to vertical position of the speakers themselves, their 
location in the listening room, as well as the acoustical charac-
teristics of the room, are also very important. As it is impos-
sible to indicate a typical location of speaker systems without a 
few tests, we suggest several general rules that are important to 
apply in order to obtain the best listening results.

Optimal positioning for a 2.0 or stereo system

4

􀀀  For the ideal positioning of your speakers follow diagram. 
If «d» is the distance between the two speakers, this distance 
must be higher than 5 ft (1.5 m) and the two speakers must 
be at equal distance from the listening area which forms with 
them an equilateral triangle.
􀀀  The drivers must be directed towards the listening area.
􀀀  The speakers should be located so that their diffusion fol-
lows the longest dimension of the room.
􀀀  Generally speaking it is better to avoid putting the speakers 
in the corners of a room as this amplifies the low frequencies 
and tends to enhance the room resonances. If possible it is 
better to place the speakers at least 8 inches (20 cm) from 
the walls.
􀀀  Moreover, in order to obtain a more accurate frequency 
response, it is recommended to raise a compact speaker from 
12 to 16 inches (30 to 40 cm) above the floor by placing them 
on stands. The tweeters of the speakers must be roughly at

the same height of the listener’s ear when the listener is in 
sitting position.
􀀀  No solid object or piece of furniture should be placed 
between the speakers and the listener. An effect of mask, 
even partial disturbs completely the sound reproduction as it 
attenuates the high frequencies and also, in most cases, the 
midrange frequencies.
􀀀  Placing the speakers in niches is not recommended. Unless 
designed for this application, bookshelf placement will alter 
the frequency response of the speaker, especially in the low 
frequencies. If a bookshelf location cannot be avoid, the 
speaker should be set up to minimize various resonance, and 
the visible part of the grille must be outside the niche.

WEEE MARK 

Disposal of Wastes of Electrical & Electronic 

Equipment (Applicable in the European Union)

This symbol on the product, consisting of the crossed- out 
wheeled bin, indicates that this product shall not be treated 

as household waste. Instead it shall be handed 
over to the applicable collection point for the 
disposal of electrical and electronic equipment 
at the end of life. By ensuring this product is 
disposed of correctly, you will help prevent 
potential negative consequences for the 

environment and human health, which could otherwise be 
caused by inappropriate waste handling of this product. The 
recycling of materials will help to preserve natural resources. 
For more detailed information about recycling of this product, 
please  contact  your  local  city  office,  your  household  waste 
disposal service or the shop where you purchased the product.

ANTIGUA MC170 - JERSEY MC170 - SOCOA MC170

ATTENTION :

 These speakers are very heavy, so 2 persons 

minimum are required to unpack and re-pack them.

Summary of Contents for MC 170













Reviews: