15
6
Configuration
i
Note!
The values of the setup are basic settings for the current printer/applicator combination.
After changing the applicator or printer a re-adjustment may be necessary.
Changes required for processing different print jobs should be implemented by additional offsets available in the
software.
The offset values from setup and software are added together for execution.
For detailed instructions for configuration
Configuration Manual of the printer.
6.1
Settings of the Printer Menu
i
Note!
In that chapter are described the specific applicator parameters of the menu
Labelling
only.
For more information about the configuration
Configuration Manual of the printer.
Start menu.
Select
Setup >
Labelling
.
Parameter
Description
Default
Device info
Applicator information:
Software edition, diameter of the last product,
number of label applications, error notes, number of rotations
Calibrate device
Calibration of the diameter measurement by means of a product with a diameter of 10 mm
With service key inserted the diameter of the calibrating product can be set.
Reset service
counter
Access only with service key inserted!
Reset of the applicator’s service counter
Cycle sequence
Select type of operation:
Print-apply
:
Printing a label and applying it to an item are triggered by a START signal.
After a cycle has finished, the transport module contains no label.
Apply-print
:
Printing an initial label is triggered by a separate signal, so is its transfer to
the transport module.
A START signal triggers the label be applied and, in subsequence, the
printing of another one.
After a cycle has finished, the transport module contains a label.
Print-apply
Automatic FSTLBL
¾
only with
Cycle sequence
=
Apply-print
The FSTLBL signal is triggered automatically in subsequence to a print job
been started.
Off
Peel-off position
Shifting the peel-off position with reference
to the rear margin of a label
Modification is possible also via software.
Configuration values add up with those of software.
0.0 mm
Wrap start
Labeling is triggered automatically by inserting a product or by an external
signal
Automatic
Check for product
Access only with service key inserted!
Checking of the centering panel state
Enabled
Table 3
Menu
Labelling
