
cab Produkttechnik GmbH
49
Appendix I - Installing Dispenser Kit
1. Turn off the printer power and unplug the printer.
2. Unwrap the PC bag of dispenser kit to take out the screw, the shaft, the plastic roller, the
dispenser bar, the direction label and the peelersensor cable.
Top Cover
3. Take off the top cover of the printer.
4. The peeler sensor cable has a sensor board at one end and a connector at the other
end.
5. Mount the two little holes of the sensor board on the two spines at left upper corner
inside the top cover, keeping the cable at the left.
6. Route the peeler sensor cable through the guides along the left side of the top cover.
7. Fix the sensor cable and sensor board with Loctite-444 instant adhesive or equivalent.