C2R Colibri 5 Series, User Manual

Page: 127 / 168

Colibri serie 5 : User’s guide
© 2000-2008 C2R Technologie, Sarl. All rights reserved
127
Rev. C
Example: Example #3: What is the device‟s current setting for Codabar Coding Enable?

Enter : cbrena?.

Response : CBRENA1[ACK]
This response indicates that the device’s Codabar Coding Enable (CBRENA) is set to 1, or on.
Example: Example #4: What are the device‟s settings for all Codabar selections?

Enter : cbr?.

Response : CBRENA1[ACK], SSX0[ACK], CK20[ACK], CCT1[ACK], MIN2[ACK],
MAX60[ACK], DFT[ACK].
This response indicates that the device’s Codabar Coding Enable (CBRENA) is set to 1, or on; the
Start/Stop Character (SSX) is set to 0, or Don’t Transmit; the Check Character (CK2) is set to 0,
or Not Required; concatenation (CCT) is set to 1, or Enabled; the Minimum Message Length
(MIN) is set to 2 characters; the Maximum Message Length (MAX) is set to 60 characters; and the
Default setting (DFT) has no value.
Trigger Commands
You can activate and deactivate the imager with serial trigger commands. First, the imager must
be put in Manual/Serial Trigger Mode either by scanning the Manual/Serial Trigger Mode bar code
(page 31), or by sending the Manual/Serial Menu Command (page 132). Once the imager is in
serial trigger mode, the trigger is activated and deactivated by sending the following commands:
Activate: SYN T CR
ASCII : CHR$(22) + CHR$(84) + CHR$(13)
HEX : 16 – 54 - 0D
Deactivate : SYN U CR
ASCII : CHR$(22) + CHR$(85) + CHR$(13)
HEX : 16 – 55 - 0D
The imager scans until a bar code has been read, until the deactivate command is sent, or until
the serial time-out has been reached (see "Read Time-Out" on page 31 for a description, and the
serial command on page 129).
Resetting the Standard Product Defaults
If you aren‟t sure what programming options are in your imager, or you‟ve changed some options
and want the factory settings restored, scan the
Standard Product Default Settings bar code
below.
The chart on the following pages lists the factory default settings for each of the menu commands
(indicated by an asterisk (*) on the programming pages).