C2R Colibri 5 30-001, User Manual

Page: 44 / 168

Colibri serie 5 : User’s guide
© 2000-2008 C2R Technologie, Sarl. All rights reserved.
44 44
Rev. C
69 code identifier for Code 93
0012 C - Code 93 sample length (11) plus CR suffix (1) = 12
43 start character match for Code 93, 43h = “C”
FF termination string for third code
Output Sequence Editor
Enter Sequence Default Sequence
Require Output Sequence
When an output sequence is
Required , all output data must conform to an edited sequence or
the imager will not transmit the output data to the host device. When it‟s On/Not Required , the
imager will attempt to get the output data to conform to an edited sequence, but if it cannot, the
imager transmits all output data to the host device as is.
When the output sequence is
Off , the bar code data is output to the host as the imager decodes
it.
Note: This selection is unavailable when the Multiple Symbols Selection is turned on.
Multiple Symbols
Note:
This feature does not work when the Imager is in Low Power mode.
When this programming selection is turned On , it allows you to read multiple symbols when the
trigger is activated. If you press and hold the trigger, aiming the Image r at a series of symbols, it
reads unique symbols once, beeping (if turned on) for each read. The imager attempts to find and
decode new symbols as long as the trigger is activated. When this programming selection is
turned
Off , the Imager will only read the symbol closest to the aiming beam.