5.4
Wireless Devices
Use the “Wireless devices” tab to record wireless devices and their parameters, such as type, entry delay, exit delay,
etc.
All wireless devices are connected to the “Nord GSM” device via the CN-WRL expander. The expander supports
connection of 31 devices. The entire list of devices is on the [site] (https://shop.cnord.ru/sn.html).
5.4.1
Connection of New Device
Figure 50: Device adding,
≪
Wireless devices
≫
tab
Most of Devices
To connect devices CN-PIR, CN-PIR-Outdoor, CN-PIR-Mini, CN-Magnetic, CN-Magnetic-Mini, CN-Glass, CN-
Fire, CN-Flood, CN-Flood-Mini, CN-Celsius , CN-Keypad, CN-Repeat, CN-Repeat 220, CN-Exit, CN-Smoke it is
necessary to:
∙
Remove the device cover;
∙
Install the batteries;
∙
Click the button “Add Wireless Device ” on the “Wireless devices” tab of the configurator;
∙
Switch the wireless device to the connection mode by briefly closing the “Reset” contacts.
The green device LED will confirm the transition to the connection mode. If the red indicator is on for 2 seconds,
it means the successful completion of the device connection.
CN-Siren
To connect devices such as “CN-Siren” and “CN-Smoke” it is necessary to:
∙
Remove the front cover, install the batteries;
∙
Click the button “Add Wireless Device ” on the “Wireless devices” tab of the configurator;
∙
Switch the wireless device to the connection mode by closing the “minus” contact of the battery holder and
contact “4” on the siren base.
If the red indicator is on for 2 seconds, it means the successful connection.
CN-KeyFob
To connect the CN-KeyFob to the device it is necessary to:
∙
Open the keyfob case, insert the battery into the holder, close the case;
∙
Click the button “Add Wireless Device ” on the “Wireless devices” tab of the configurator;
∙
Press and release any key on the keyfob. The device will periodically turn on the green indicator, indicating
that it is in the “Connection” mode. If there is no such indication, press and hold all three buttons simulta-
neously for 2 seconds or more, and the indicator shall turn green. Hold the buttons until the indicator turns
red.
If the keyfob will serve as a panic button, then after the connection it is necessary to check “Panic
button enabled”.
5.4.2
Repeater
“CN-Repeater” and “CN-Repeater 220” are repeaters designed to increase the wireless device range.
56