SYSTEM CONFIGURATION AND SETTINGS Page 24
6
SYSTEM CONFIGURATION AND SETTINGS
This section describes how to start up the system, verify its functionality
and, if needed, adjust the R4 Navigation System to its usage environment.
All parameters are set via the R4 Display. To set parameters, follow the
steps as described in the following sections.
6.1
R4 Display Keys
The R4 Display has a number of keys that are used to navigate in the menus
and enter values. The locations of the keys are illustrated in Figure 6-1.
Figure 6-1: R4 Display key names and location
The keys are described below:
POWER
Used for turning the R4 display on and off. To turn the power off,
press and hold the key for about 3 seconds.
MOB
Used to mark the spot of an event or where a person has fallen
overboard. To activate the Man Over Board (MOB) function, hold the key
for at least 5 seconds. If held shorter, the event mark functionality is
activated.
DISPLAY
Provides controls for fast configuration of backlight, contrast,
LED and button illumination.
STATUS
Not used in the R4 Navigation System.
MODE
Used for changing mode of operation, which can be set to any of
Navigate
,
Plan
Voyage
,
Alarms & Msgs
and
Config
.
ALPHANUMERIC KEYS
These keys are used for entering text and numbers.
To write a number in a numeric field press the key once. To write a
Summary of Contents for 1000 R4
Page 18: ...MOUNTING Page 12 Figure 4 7 Panel mounting R4 Display Figure 4 8 R4 Display panel mounted ...
Page 79: ...TECHNICAL SPECIFICATIONS Page 11 ...
Page 80: ...TECHNICAL SPECIFICATIONS Page 12 APPENDIX A J4N SCHEMATIC ...
Page 81: ...TECHNICAL SPECIFICATIONS Page 13 APPENDIX B J4N PCA LAYOUT ...