iNetVu™ Service Manual
Page 22 of 109
To secure the cover to the reflector, start with the opening at the base of the
reflector. Pull the cover downward over the lip of the unit and affix the Velcro
with the seam roughly at the edge as shown. The cover will leave
approximately ¼” of the reflector edge exposed.
Pull the cover tight and affix the over in the order shown above to ensure a
wrinkle-free assembly. Area 9 will remain slack in order to allow for mounting
onto the iNetVu™ Mobile Platform.
[ New Installation
: Holes are required in the cover in order to insert the
mounting bolts. Locate the mounting locations on the reflector, and use a
soldering iron or sharp knife to cut a ‘cross’ . Fastening of the reflector to the
iNetVu™ will keep the fabric from fraying
]
Once the entire perimeter has been secured, the reflector is now ready to be
mounted to the iNetVu™ Mobile Platform. Ensure that the Velcro strap is
secured after installation.
