PROTECTION & SAFETY
21
2020/06 - Indice de révision : A - Code : 34560
5.
The electrical panel
This panel features 3 buttons and 5 LEDs, as described in the table below.
As regards the first 2 LEDs, blinking signifies that learning is underway, while a fixed light indicates that learning
must be carried out (for the first two LEDs), or that the anti-tear has been triggered (for the 2nd LED only).
If the 5th LED is lit up, this means that there is a fault on the motor sensor signal line.
Ends of
travel
Anti-tear
Not used
Motor
sensor
signal
Validation of
the closed
position
Validation of
the open
position
Validation of
the step
performed
The PCB automatically manages stopping of the cover apron when it is fully opened or closed. The exact
positions must be established and saved when the cover is commissioned according to following procedure and
steps. These positions may be altered at any time by following the same procedure.
5.1.
Initialisation of the printed circuit board
On the control panel, all the LEDs are out.
Hold these keys down for 5 seconds:
All five LEDs will blink.
Press OK briefly.
The first two LEDs will light up, initialisation is complete.
5.2.
Validation of the direction of rotation of the axle
Insert the key into the key switch. When the key is turned to FERM, the cover apron should roll out over the pool.
When turned to OUV, the cover apron should roll up around the axle.
NOTA BENE
: it is normal for the key to return to the 0 position when it is released.
If the direction of rotation is inversed with respect to the markings on the key switch, change the position of
dipswitch 1 (see above) on the printed circuit board.
5.3.
Programming the ends of travel
Turn the key and hold it in position until the cover apron reaches the side opposite
the axle. Validate the pool closed position by pressing
. The leftmost LED starts
to blink and the second is lit up.
