Buyers 8883200, Manual

Page: 8 / 20

Before Beginning Installation
8
Camera
The camera and monitor will require their own power
sources routed individually to each component. They do
not have a cable that interconnects. Do not run power
wires over sharp edges. Keep power wires away from
HOT and/or rotating parts such as, but not limited to,
exhaust systems and drive shafts.
Monitor
1. The monitor will require being wired to power source
such as keyed on ignition or switched power.
2. If needed, a minimum of a 7/8" hole will be required to
pass the monitor wire junction through.
3. Connect the monitor trigger wire according to the
camera location to the appropriate trigger source such
as a reverse or turn signal circuit.
4. Mount the monitor using the provided U-bracket or
suction cup pedestal.
Once all cables have been properly routed, power on the
system and check that the system is paired. If the system
is paired, meaning the camera can be manually selected,
but the trigger wire does not activate the camera - see
page 10 on how to change which channel the camera is
paired to.