7.
Insert the four-pin header connector from the drive activity LED on the
front panel of the host to connector on the
This connector is
reversible and may be plugged into in either direction.
LED cable
Pin 1
LED connector
Figure 2-6. LED Cable installation Detail
Verify that all connections are secure.
Reattach and close the cover of the host computer as described in the
system owner’s manual.
2.
3.
Updating System CMOS
Once hardware installation is complete and the host computer is reas-
sembled, power up the system.
Run SETUP and configure the host CMOS RAM options. Set the drive
type option for SCSI drive to No Hard Drive Installed.
Reset the system to activate your SETUP changes.
Adapter Configuration
This section describes:
n
How to use the host adapter configuration utility. Host adapter config-
uration is optional. You may skip this section and proceed to Section 4.
n
A diagnostics test that checks adapter/motherboard connectivity
Resource Parameter Configuration
For most installations, the adapter will operate successfully with its facto-
ry-default configuration. It may need to be changed if resource conflicts oc-
cur. When further configuration is required, use the
Utility
described below.
Every BT-445C comes with an
configuration utility, AutoSCSI,
The
Utility
which resides in Read Only Memory (ROM). AutoSCSI is a menu-based tool
for configuring
SCSI host adapters. You can use AutoSCSI to set or
change SCSI and
parameter configuration. In addition to its
simplified configuration, AutoSCSI offers diagnostics and disk utilities.
Note: While previous generation
adapters installed in the host system
are detected and appear in
they cannot be configured using this
utility.
Installation
Adapter Configuration 3-l
Summary of Contents for BT-440C
Page 1: ... z p ...
