BusLogic BT-440C, Installation Manual

Page: 8 / 23

Installing the Adapter
To install the adapter, remove the mounting screw and the existing
bracket from the rear panel behind the selected 32-bit VL slot.
2. Press the downward into the selected 32-bit VL slot, align the
mounting bracket, and reinstall the mounting screw.
Caution: Make sure that the board is properly seated in the slot.
3.
Connect the SCSI cable to the adapter’s single-ended SCSI con-
J3, attaching the other end to the SCSI device. Place the connec-
tor cable around the power supply and over any other boards.
Depending on the configuration of your computer, other types of cables
could be used.
Internal
Internal SCSI Connector
SCSI Disk
Floppy Drive
Drive Drive
Motherboard
External SCSI
Connector
Figure 2-3.
Installation
Before plugging in cable connectors, check that the mark molded
on the connector or the colored stripe on the cable (indicating the loca-
tion of Pin matches Pin 1 of the connector on the BT-445C board.
connector
Pin
Figure 2-4. SCSI Cable Installation Detail
4. connecting to a floppy drive, insert the floppy cable from the
floppy drive into the floppy connector only).
1
connector
Figure 2-5. BT-445C Floppy Cable Installation Detail
2-6
n
Installation
Installation 2-7