Set Up
Before using the appliance, it is important to prepare the appliance by installing
the proper adaptors to suit our intended use. In this example, we will be preparing
the portable water heater to be used with a hose input from a 12-volt pump.
1.
Remove the heater along with all the
components from the box and place
them on a table. Notice that there is a
gas input, hot water output, cold water
input as well as a battery box.
5.
Fit and tighten the hose fitting with a
spanner, taking care not to over tighten
as this could break or crack the inlet
pipe. The ‘gas input’ is now ready to be
connected to the gas regulator hose.
7.
Tighten the hose, taking care not
to over tighten as this could break or
crack the inlet pipe.
10.
Attach the shower rose to the
flexible shower hose using the conical
end fitting. Hand force only. Do not
over tighten.
8.
Connect free end of Water Hose
to the outlet side of the pump. Use a
hose clamp to fix hose to pump. Attach
other hose to inlet of pump with hose
clamp. See Page 15 for more details.
9.
Fit seal to chrome flexible shower
hose, then attach hexagonal end to
the ‘water out’ connection (middle
connection) on the water heater. Do
not over tighten.
Seal (Clear rubber washer):
Ensure a seal (supplied) is inserted into
the connector at both ends of the
flexible shower hose.
6.
Attach black inlet hose to unit via
crimped swivel fitting. Ensure a seal is
inserted into the fitting.
3.
Locate the Gas Hose and Regulator.
It requires a black rubber seal to be
inserted into the end shown below.
Seal (Black
Rubber Washer)
Seal (Black
Rubber Washer)
Seal (Clear
Rubber Washer)
Seal (Black rubber washer):
Seal (Black rubber washer):
4.
DO NOT USE TEFLON TAPE on the
gas or water fittings. The unit has been
designed to be assembled with the use
of rubber washers.
2.
Insert two ‘D’ batteries into the
‘battery box’ and close the battery box
lid. Note: The orientation of the battery
terminals.
On/Off
| Gas Hot Water Shower
|Gas Hot Water Shower
Page 9
Page 10
Summary of Contents for 78X04
Page 1: ...78X04 ...
