Bush LSBGHP, Instruction Manual

Page: 15 / 30

Installing your #VJMUJO(BT)PC
Bringing it all together
Connection to the gas supply
The gas c onnection must be made in accordance with the local
standards. When installin g, fit a safety tap at the end of the
pipeline. The appliance leaves the factory tested and set for the
type of gas indicated on the plate inside the bottom guard, close
to the gas connection pipe. Make sure that the type of gas to be
supplied to the appliance is the same as that shown on the plate.
Otherwise, follow the instructions provided in the “Adapting to
different types of
gas” section.
For maximum efficiency and minimum consumption, make sure
that the gas supply pressure complies with the values shown in
the gas used is different from that specified (or variable).a
suitable pressure regulator must be installed on the supply
pipeline.
The union must be fitted on the end of the gas train. Complete with GJ1/2 ＂ threaded nut,
fitting the gasket between the components as shown in the illustration. The gaskets
must comply with the local standards. Screw the parts together without forcing, fit the
union so that it points in the direction required then tighten all parts.
Connection
Make the connection to the gas system using a rigid metal pipe and regulation unions, or
with a stainless steel hose complying with the local standard. If metal hoses are used,
take care that they do not come into contact with mobile parts and are not crushed.
This must also be checked if the hob is to be combined with an oven.
The gas intake connection of the appliance has a “ male thread.”
When making the connection, take care not to apply stresses of any kind to the
appliance.
When the installation is complete, always check that all the unions are absolutely
tight using a soapy solution. Never use a flame to make this check.
Installing your #VJMUJO(BT)PC
1 5
or online at www. CVTI - support.c om I f you still require further assistance, call one of our experts on 01759 487838.