Bush LSBGHP, Instruction Manual

Page: 17 / 30

Installing your #VJMUJO(BT)PC
Bringing it all toget IFS
Adapting to the different types of gas
Changing the nozzles
1) Remove the pan standee.
2) Remove the burner caps and flame caps from the burners.
3) Use a size 7 socket wrench to unscrew and remove the nozzles,
replacing them with those corresponding to the type of gas to be
used (see the table ).
4) Reassemble the parts, reversing the operations described
above.
5) Then replace the setting data (close to the mains gas
connection)
with the one for the new type of gas . If the pressure of the gas used
is different from that specified (or variable), a suitable piped gas pressure
regulator complying with the standard must be installed on the supply pipeline.
Setting the minimum level
1) Light the burner as already described.
2) Turn the tap to the minimum flame position.
3) Remove the control knobs.
4) LPG TO NG:
Use a thin blade screwdriver to turn the by-pass screw
located above left of the gas valve, shaft as shown right. Turn
gently the by-pass screw clockwise to the end completely
then turn it anti-clockwise 1/2 turn for the Triple flame burner, 3/4 turn for the Large
rapid burner, 1/2 turn for the Medium Semi-rapid Burner
and 3/8 turn for the Auxiliary burner.
NG TO LPG:
Use a thin blade screwdriver to turn the by-pass screw located above left of the gas
valve shaft as shown right. Turn gently the by-pass screw clockwise to the end.
5
）
Finally, check that the burner does not go out when the tap is turned quickly from the
maximum to the minimum position.
Installing your #VJMUJO(BT)PC
7
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,