Bush Power G3000X, Operating Instructions Manual

Page: 19 / 43

2. Start engine according to “STARTING THE ENGINE”
When the output indicator light (green) does not light and the
overload indicator light (red) lights instead, set the engine switch to
STOP, stop the engine at once and then start the engine again.
3.
Confirm that the equipment to be used is switched off, and insert the
plug of the equipment to be used into the AC receptacle unit A.
Check that the equipment to be connected is switched off. When the
equipment to be used is switched on, it will operate suddenly, and
injuries or accidents may be caused.
4. Switch on the equipment output indicator light will light up. In case
of overload operation or when trouble occurs for the equipment
being used, the output indicator light (green) will go out, the overload
indicator light (red) will light continuously, and no power will be put
out. At this time, the engine will not stop, so that the engine must be
stopped by setting the respective engine switch to STOP.