![background image](http://html1.mh-extra.com/html/bush-hog/rmb-1660/rmb-1660_operators-manual_2834701042.webp)
ASSEMBLY
RMB 1660 11/10
Assembly Section 3-4
© 2010 Alamo Group Inc.
ASSEMBL
Y
Suggestions to increase stability:
•
Increasing rear wheel track; a tractor with a wider wheel track is more stable.
•
Ballasting the wheel; it is preferable to use external weights but liquid can be added to around 75% of the
tire volume – water with anti-freeze or the heavier Calcium Chloride alternative can be used.
•
Addition of weights – care should be taken in selecting the location of the weights to ensure they are added
to a position that offers the greatest advantage.
•
Front axle locking; a cylinder can be used to ‘lock’ the front axle in work only – locking the axle moves the
‘balance line’ and can be used to transfer weight to the front axle from the rear (check with tractor
manufacturer).
The advice above is offered as a guide for stability only and is not a guide to tractor strength - it is therefore
recommended that you consult your tractor manufacturer or local dealer to obtain specific advise on this
subject, additionally advice should be sought from a tire specialist with regard to tire pressures and ratings
suitable for the type and nature of the machine you intend to fit.
DEALER SETUP INSTRUCTIONS
1.
The machine will be delivered in a partially
dismantled condition, secured with transport
strap and banding.
2.
Choose a firm level site.
3.
Remove the transport strap, banding straps and
loose items.
4.
Check the oil level.
5.
Raise the machine using overhead lifting
equipment with a minimum capacity of 3307
lbs. LEAVE IN POSITION AT THIS STAGE.
6.
Lower the legs and pin in position selecting the
holes that position the machines gearbox stub
shaft approx. 3” below the tractors P.T.O. shaft.
NOTE: Leg pin position used.
7.
Unbolt stabilizer from machine and remove the
stabilizer nose quadrant pin.
Summary of Contents for RMB 1660
