ASSEMBLY
RMB 1660 11/10
Assembly Section 3-11
© 2010 Alamo Group Inc.
ASSEMBL
Y
•
Fit PTO shaft in position.
•
Attach safety chains (A) on driveline to a
convenient location to prevent rotation of the
shaft guarding.
•
Ensure the Lift Cylinder shut-off valve and Slew
Cylinder shut-off valve are open.
•
Operate the lift up controls and raise the dipper
arm end just enough to clear the ground.
•
Pivot out the dipper arm until the tension link can
be connected.
Do Not attempt to raise or lower the boom or mower head unless the Implement is securely
attached to the Tractor. The Implement could tip over and cause equipment damage and
possible serious injury or death. Do Not use the boom controls to assist in installing the
implement on the tractor. Raise or Lower the boom and mower head only while seated in
the Tractor operator’s seat with the seat belt securely fastened. Inadvertent contact with
the boom controls could allow a component to fall. A sudden or inadvertent fall by any of
these components could cause serious injury or even death.
(SBM-23)
Summary of Contents for RMB 1660
