![background image](http://html.mh-extra.com/html/bush-hog/rmb-1445/rmb-1445_operators-manual_2834700052.webp)
ASSEMBLY
RMB 1445 11/10
Assembly Section 3-10
© 2010 Alamo Group Inc.
ASSEMBL
Y
When adding hydraulic oil, use only new oil from a sealed barrel. Used oil or oil from an open barrel may
contain high levels of contamination. Transfer the oil into the hydraulic tank by using a hydraulic filter pump unit
equipped with a properly operating 10 micron filter. This will insure that the oil being added is clean. Do not just
pour the oil directly into the hydraulic tank since most oils (even from a sealed barrel) have contaminants that
should be removed, before operating the hydraulic system.
(Asm-B-0010 & Asm-B-0103)
Gearbox
Check the gearbox oil level. On level ground, gearbox should be filled until oil is visibly level with the lip of the
filler plug aperture. Do not attempt to fill by removing the breather as the depth of tapped thread in the casing at
this point is insufficient to allow repeated loosening and tightening of the breather plug.
The gearbox capacity is 1-1/2 pints. Use EP90 gear oil.
FITTING CONTROL UNIT IN CAB
An angled bracket is supplied to provide a mounting location for the control unit.
This bracket may be bolted to the fender or cab cladding in a convenient location ensuring that no structural
member of the cab or roll bar is drilled.
In deciding the final position of the control box remember not to exceed the minimum acceptable bend radius of
8” for the cables.
When the control unit is removed from the cab ensure the rubber edge strip is fitted too the mounting bracket to
cover any possible sharp edges.
Summary of Contents for RMB 1445
