ASSEMBLY
DHM 8, 9, 10 05/19
Assembly Section 3-10
© 2019 Alamo Group Inc.
ASSEMBL
Y
Refer to Figure Asm-D-0034 and carry out the following steps in the order indicated:
1. Mount rear protection 13 on support canvas 1 as shown with five screw 14 (M10x20-25/64”x25/32”) and
nut 16 (M10-25/64) and washer 15. Use screw 42 (M10x25-25/64”x1”) to mount vertical protection 45.
DO NOT USE HOLE 43 AT THIS TIME.
2. Mount the three pivoting supports 17 on support canvas 1 shown with three screws 18 (M12x75-15/32x2-
15/16”) and self-locking nuts 19 (M12-15/32”).
NOTE:
Do not fully tighten the screws 18 to let pivoting the front protection.
3. Mount front protection 20 on pivoting supports 17 as shown with five screw 21 (M10x20-25/64”x25/32”)
and nut 22 (M10-25/64”) and washer 23.
DO NOT USE HOLE 41 AT THIS TIME.
4. Mount plugs for pipe 9 (ø27-2.5-ø1-1/16”x3/32”).
Summary of Contents for DHM Series
